marrold
marrold
About
- Username
- marrold
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
Comments
-
Hi, just a heads up this issue re-occured, the CAD was disconnected from the power, ran down the batteries and then wouldn't start until the batteries were replaced. Has there been any progress on adding an alert to the app, or an email, if the CAD…
-
Hi Jane, Thanks for the response. Unplugging the CAD wasn't intentional on this occasion, it was unplugged by mistake to plug something else in and because there was no alert it ran flat over night. Thanks again!
-
The valuables I was getting as is seemed plausible at first but I spotted gaps in my data which turned out to contain a letter so couldn't be plotted on a graph. Since converting from a signed integer there's no more gaps and the number matches that…
-
Just in case anyone stumbles across this in future, the LQI is a signed integer too. Initially I saw "60" and assumed it was as-is, but after some missing data in Grafana I realised it is in fact in the same format as the RSSI
-
Thanks ghayne, I hadn't paid attention to those! I'm guessing the RSSI is a signed integer in Hex? Mine is currently B5 which converts to -75, which seems about right. Can the lqi be used as is?
-
I mentioned it on another thread but I'll put it here too for visibility, I'd love to see some lower level metrics exposed via MQTT - Volts, Hertz, Power Factor etc. I'm not sure if these metrics are available to you? Obviously I understand your ave…
-
I'm not following the exact method shown above but I've started importing data from the MQTT feed into InfluxDB / Grafana Heres my quickly thrown together dashboard - https://s3.eu-west-2.amazonaws.com/cdn.marrold.co.uk/images/glow_grafana_screensho…
-
Thanks for sharing this @sidepipe - I've got it working with Node Red + Home Assistant + Grafana - I'll share some details soon